Connected Site Monitoring
Plug in a router and discover every device on site in 60 seconds. Monitor, alert, and respond across multi-device sites, without agents, integrations, or specialist engineering.
Remote sites with multiple devices are hard to monitor
Remote and distributed sites often contain multiple devices from different vendors. Traditional monitoring requires agents installed on each device, vendor-specific integrations, and specialist engineering to set up and maintain.
- Multiple devices from different vendors on each site
- Traditional monitoring requires agents installed on every device
- Vendor-specific integrations are complex and expensive to maintain
- Specialist engineering needed to set up and configure monitoring
Plug in, discover, monitor, in 60 seconds
Connect a SIMSY-enabled router to your site network. Within 60 seconds, every device on the LAN is auto-discovered and identified. DNAT data collection begins immediately, no agents, no integrations, no specialist setup.
- Auto-discover all LAN devices within 60 seconds of connecting
- DNAT data collection gathers device data without agents
- Monitor, alert, and respond from a single platform
- No vendor-specific integrations or specialist engineering required
What the platform delivers
Auto-discovery
Connect a router to the site LAN and every device is automatically discovered within 60 seconds. No manual configuration, no device list to maintain, no scanning tools to run.
Vendor Identification
Discovered devices are automatically identified by vendor, type, and network characteristics. You get a clear picture of what is on each site without manual asset surveys.
DNAT Data Collection
Data is collected from devices at the network layer using DNAT. No agents to install, no software to maintain, no device-side configuration. Works with any device that has a network connection.
Anomaly Detection and Alerts
Automatic detection of unusual device behaviour, connectivity changes, and performance anomalies. Alerts delivered via webhook the moment something requires attention.
Remote Access
Access any discovered device remotely through any browser. Diagnose issues, check status, and resolve faults without sending an engineer to a remote site.
Compliance Logging
Every discovery event, state change, and access action is logged automatically. Complete audit trail for every device on every site, generated as a byproduct of monitoring.
Before and after SIMSY
What this means for your operation
Frequently asked questions
When you connect a SIMSY-enabled router to a site LAN, it automatically scans and discovers every device on the network. Devices are identified by MAC address, vendor, type, and network characteristics within 60 seconds.
Yes. Auto-discovery and DNAT data collection work at the network layer, so they are vendor-agnostic. Any device with a network connection can be discovered, identified, and monitored regardless of manufacturer.
Connected site monitoring is designed for any remote or distributed site with multiple networked devices, industrial facilities, retail locations, energy sites, construction sites, or any environment where multiple devices need monitoring.
Yes. Adding a new site is as simple as connecting a SIMSY-enabled router to the site LAN. Discovery, identification, and monitoring begin automatically. No specialist configuration or engineering is required.
Ready to monitor your sites?
Talk to us about connected site monitoring. Plug in a router, discover every device, and start monitoring in 60 seconds.